Added ARMCC V6 support [EP-435, EP-844, EP-1195]
      Added IAR support [EP-904, EP-1470]
      Corrected syntax errors in svd file [EP-1455]
      Removed PLL [EP-662]
      Added MOTIX(TM) Branding [EP-934]
      Updated User Manual and Firmware User Manual [EP-1453]
      ADC1: Corrected ADC1_ESM_T RIG_SEL description [EP-1057]
      ADC1: Corrected doxygen documentation [EP-950]
      ADC2: Corrected attenuator values for VDDEXT and VDDP [EP-447]
      ADC2: Show protected value in XML (as read-only) [EP-446]
      BDRV: Added adaptive sequencer to Config Wizard [EP-444]
      BDRV: Removed 'not found in svd' errors in Half-Bridge XML [EP-445]
      BDRV: Removed BDRV.CP_CTRL.VCP_LOWTH2 [EP-867]
      BDRV: Removed Charge Pump UV threshold configuration [EP-1404]
      BDRV: Removed VCP_LOTH2 [EP-1450]
      BootROM: Corrected error codes [EP-450]
      Config Wizard: Added link to MOTIX MCU forum [EP-1198]
      PMU: Added clearing of GPIO wake sts registers in stop mode entry [EP-825]
      PMU: Removed lock to GPIO Wake when using stop mode [EP-1081]
      SCU: Corrected SYSCLKSEL usage [EP-635]
      SCU: Updated field accesses in Clock Init [EP-426]
      SSC: Corrected Baud rate detection error enable [EP-692]
      WDT1: Corrected delay function [EP-768]

      Updated DC motor example to match AppNote "TLE985x Bridge Driver Getting Started"    
      ADC1: Corrected Post-Processing unit usage in Config Wizard
      ADC2: Corrected calculation of LSB voltage
      CCU6: Corrected dead time calculation
      SSC: Updated baudrate selection
      UART: Updated baudrate selection
      UART: Updated pin selection for UART1 (GPIOs or LIN)
      Updated disclaimer

      Added support for TLE9850QX, TLE9852QX, and TLE9854QXW
      Added new Data Sheets
      Update of default values in XML file

      Added DC motor example for TLE9855 EvalKit
      CCU6: CCU6 registers displayed correctly in debugger
      UART: Corrected ranges for UART1_BaudRate_Set and UART2_BaudRate_Set
      SCU: Removed unused initialization of SCU->MODPISEL3,
      Set LIN to sleep mode only if the LIN module is enabled
      BDRV: Set APCLK_SET after modifying SCU->BRDRV_CLK.reg to apply clock changes,
      Corrected value of define BDRV_IRQ_CLR_BITS to clear all interrupts 
      ADC1: Removed initialization of ADC1_CAL_CHx_y in ADC1_Init as these registers are initialized by the BootROM

      Firmware user manual added
      scu: added open/close password where necessary
      adaption to new PACK deployment process

      SDK Unit tested
      MISRA 2012 compliant
      ARMCC v6 support

      XML update
      ADC1 update

      TLE985x Device Family Pack.
      BDRV Motor Control Example added.
      Flash Programing Examples added.
      Improved GUI for Config Wizard.
      Bug fixes.

      TLE985x Device Family Pack.
      Full SDK including examples.