The flexio_spi_slave_interrupt_lpspi_master example shows how to use flexio spi slave driver in interrupt way. In this example, a flexio simulated slave connect to a lpspi master.

The flexio_uart_edma example shows how to use flexio uart driver in edma way:In this example, a flexio simulated uart connect to PC through USB-Serial, the board will send back all charactersthat PC send to the board.

The flexio_uart_interrupt_ring_buffer example shows how to use flexio uart driver in interrupt way withRX ring buffer enabled:In this example, a flexio simulated uart connect to PC through USB-Serial, the board willsend back all characters that PC send to the board.Note: The example echo every 8 characters, so input 8 characters every time.

The flexio_uart_interrupt example shows how to use flexio uart driver in interrupt way:In this example, a flexio simulated uart connect to PC through USB-Serial, the board will send back all charactersthat PC send to the board. Note: two queued transfer in this example, so please input even number characters.

The flexio_uart_polling example shows how to use flexio uart driver in polling way:In this example, a flexio simulated uart connect to PC through USB-Serial, the board will send backall characters that PC send to the board.

The GPIO Example project is a demonstration program that uses the KSDK software to manipulate the general-purposeoutputs.The example is supported by the set, clear, and toggle write-only registers for each port output data register. The example uses the software button to control/toggle the LED.

The GPIO Example project is a demonstration program that uses the KSDK software to manipulate the general-purposeoutputs.The example is supported by the set, clear, and toggle write-only registers for each port output data register. The example take turns to shine the LED.

The Hello World demo application provides a sanity check for the new SDK build environments and board bring up. The HelloWorld demo prints the "Hello World" string to the terminal using the SDK UART drivers. The purpose of this demo is toshow how to use the UART, and to provide a simple project for debugging and further development.

The LED Blinky demo application provides a sanity check for the new SDK build environments and board bring up. The LED Blinky demo uses the systick interrupt to realize the function of timing delay. The example takes turns to shine the LED. The purpose of this demo is to provide a simple project for debugging and further development.

The lpi2c_edma_b2b_transfer_master example shows how to use lpi2c driver as master to do board to board transfer with EDMA:In this example, one lpi2c instance as master and another lpi2c instance on the other board as slave. Master sends a piece of data to slave, and receive a piece of data from slave. This example checks if the data received from slave is correct.