MIMXRT1060-EVKB

The SDCARD Polling project is a demonstration program that uses the SDK software. It reads/writes/erases the SD card continusly. The purpose of this example is to show how to use SDCARD driver andshow how to use polling based transfer API in SDHC driver in SDK software to access SD card.Note: If DATA3 is used as the card detect PIN, please make sure DATA3 is pull down, no matter internal or external, at the same time, make sure the card can pull DATA3 up, then host can detect card through DATA3.And SDHC do not support detect card through CD by host, card can be detected through DATA3 or GPIO.No matter detect card through host or gpio, make sure the pinmux configuration is correct.

This project can be used to get SE05X platform information.

This project can be used to get SE05X platform information.

This is a bare minimum example for se050. This gets the amount of free memory.

This is a bare minimum example for se050. This gets the amount of free memory.

This example does a elliptic curve cryptography signing and verify operation.

This example does a elliptic curve cryptography signing and verify operation.

The vcomSE050 demo application allows the board to be used as a bridge between the PC and the secure module and enables the execution of the config tool and other utilities from the PC.

The vcomSE050 demo application allows the board to be used as a bridge between the PC and the secure module and enables the execution of the config tool and other utilities from the PC.

The sdramc example shows how to use SEMC controller driver to initialize the external SDRAM chip.