The TPM project is a simple demonstration program of the SDK TPM driver. It sets up the TPMhardware block to output PWM signals on two TPM channels. The PWM dutycycle on both channelsis manually updated. On boards that have an LED connected to the TPM pins, the user will seea change in LED brightness if user enter different values.

The TPM project is a simple demonstration program of the SDK TPM driver. It sets up the TPMhardware block to output a center-aligned PWM signal. The PWM dutycycle is manually updated.On boards that have an LED connected to the TPM pins, the user will see a change in LEDbrightness if user enter different values.

The TPM project is a simple demonstration program of the SDK TPM driver to use TPM as a timer.It sets up the TPM hardware block to trigger an interrupt every 1 millisecond.When the TPM interrupt is triggered a message a printed on the UART terminal.

The uart_edma example shows how to use uart driver with EDMA:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.Note: The example echo every 8 characters, so input 8 characters every time.

The uart_interrupt_ring_buffer example shows how to use uart driver in interrupt way withRX ring buffer enabled:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.Note: The example echo every 8 characters, so input 8 characters every time.

The uart_interrupt example shows how to use uart driver in interrupt way:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.Note: The example echo every 8 characters, so input 8 characters every time.

The uart_polling example shows how to use uart driver in polling way:In this example, one uart instance connect to PC through uart, the board will send back all characters that PCsend to the board.

The WDOG Example project is to demonstrate usage of the KSDK wdog driver.In this example,quick test is first implemented to test the wdog.And then after 10 times of refreshing the watchdog in None-window mode, a timeout reset is generated.We also try to refresh out of window to trigger reset after 10 times of refreshing in Window mode.