LPC54018-IoT-Module

The power_manager_lpc application shows the usage of normal power mode control APIs for entering the three kinds of low power mode: Sleep mode, Deep Sleep mode and Sleep Power Down mode. When the application runs to each low power mode, the device would cut off the power for specific modules to save energy. The device can be also waken up by prepared wakeup source from external event. Tips: This demo is to show how the various power mode can switch to each other. However, in actual low power use case, to save energy and reduce the consumption even more, many things can be done including: - Disable the clock for unnecessary module during low power mode. That means, programmer can disable the clocks before entering the low power mode and re-enable them after exiting the low power mode when necessary. - Disable the function for unnecessary part of a module when other part would keep working in low power mode. At the most time, more powerful function means more power consumption. For example, disable the digital function for the unnecessary pin mux, and so on. - Set the proper pin state (direction and logic level) according to the actual application hardware. Otherwise, the pin cirrent would be activied unexpectedly waste some energy. - Other low power consideration based on the actual application hardware. - In order to meet typedef power consumption of DateSheet manual, Please configure MCU under the following conditions. 鈥?Configure all pins as GPIO with pull-up resistor disabled in the IOCON block. 鈥?Configure GPIO pins as outputs using the GPIO DIR register. 鈥?Write 1 to the GPIO CLR register to drive the outputs LOW. 鈥?All peripherals disabled.

The example shows how to us USBD ROM stack to creates a generic HID device. The example supports 1 byte report and loops back the data received in SET_REPORT message..

The example shows how to use USBD ROM stack to create a RAM disk. When the USB on J3 is connected to a PC, the host would recognize the USB connection as a mass storage device. Note that the storage happens on the RAM and is not a persistent storage..

The SCTImer multi-state project is a demonstration program of the SCTimer state machine. It shows how to set up events to be triggered in a certain stateand transitioning between states.State 0 has 2 events that generate a PWM signal, it also has an event linked to an input signal to transition to State 1.State 1 has 4 events that generate 2 PWM signals, it also has an event linked to an input signal to transition to State 0.

The spi_interrupt_b2b_master example shows how to use spi functional API to do interrupt transfer as a master:In this example, the spi instance as master. Master sends a piece of data to slave, receive data from slave,and checkif the data master received is correct. This example needs to work with spi_interrupt_b2b_slave example.

The SPIFI Polling Example project is a demonstration program that uses the KSDK software to program external serialflash using polling and read through AHB bus.

The uart_interrupt_ring_buffer example shows how to use uart driver in interrupt way withRX ring buffer enabled:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.Note: The example echo every 8 characters, so input 8 characters every time.

The uart_interrupt example shows how to use uart driver in interrupt way:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.Note: The example echo every 8 characters, so input 8 characters every time.

The purpose of this demo is to show wakeup from deep sleep mode using MicroTick timer.The demo sets the MicroTick Timer as a wake up source and puts the device in deep-sleep mode. The MicroTick timer wakes up the device.

The purpose of this demo is to show wakeup from deep sleep mode using MicroTick timer.The demo sets the MicroTick Timer as a wake up source and puts the device in deep-sleep mode. The MicroTick timer wakes up the device.