HVP-KE18F

The FTM project is a simple demonstration program of the SDK FTM driver to use FTM as a timer.It sets up the FTM hardware block to trigger an interrupt every 1 millisecond.When the FTM interrupt is triggered a message a printed on the UART terminal.

The GPIO Example project is a demonstration program that uses the KSDK software to manipulate the general-purposeoutputs.The example is supported by the set, clear, and toggle write-only registers for each port output data register. The example take turns to shine the LED.

The Hello World demo application provides a sanity check for the new SDK build environments and board bring up. The HelloWorld demo prints the "Hello World" string to the terminal using the SDK UART drivers. The purpose of this demo is toshow how to use the UART, and to provide a simple project for debugging and further development.

The LED Blinky demo application provides a sanity check for the new SDK build environments and board bring up. The LED Blinky demo uses the systick interrupt to realize the function of timing delay. The example takes turns to shine the LED. The purpose of this demo is to provide a simple project for debugging and further development.

The LPIT chained channel project is a simple example of the SDK LPIT driver. It sets up the LPIT hardware block to trigger a periodic interrupt after every 1 second in the channel No.0, the channel No.1 chained with channel No.0, if LPIT contain more than two channels, the channel No.2 chained with channel No.1....the channel No.N chained with Channel No.N-1. When the LPIT interrupt is triggered.

The LPIT single channel project is a simple example of the SDK LPIT driver. It sets up the LPIThardware block to trigger a periodic interrupt after every 1 second. When the LPIT interrupt is triggereda message a printed on the serial terminal and an LED is toggled on the board.

The LPTMR project is a simple demonstration program of the SDK LPTMR driver. It sets up the LPTMRhardware block to trigger a periodic interrupt after every 1 second. When the LPTMR interrupt is triggereda message a printed on the UART terminal and an LED is toggled on the board.

The lpuart_edma Example project is to demonstrate usage of the KSDK lpuart driver.In the example, you can send characters to the console back and they will be printed out onto console in a group of 8 characters.

The lpuart_functioncal_interrupt example shows how to use lpuart driver functionalAPI to receive data with interrupt method:In this example, one lpuart instance connect to PC, the board willsend back all characters that PC send to the board.

The lpuart_interrupt_ring_buffer Example project is to demonstrate usage of the KSDK lpuart driver.In the example, you can send characters to the console back and they will be printed out onto console in a group of 8 characters.