FRDM-KE06Z

The spi_interrupt_b2b_transfer example shows how to use SPI CMSIS driver in interrupt way:In this example , we need two boards, one board used as SPI master and another board used as SPI slave.The file 'spi_interrupt_b2b_transfer_slave.c' includes the SPI slave code.This example uses the transactional API in SPI driver.1. SPI master send/received data to/from SPI slave in interrupt .

CMSIS-Driver defines generic peripheral driver interfaces for middleware making it reusable across a wide range of supported microcontroller devices. The API connects microcontroller peripherals with middleware that implements for example communication stacks, file systems, or graphic user interfaces. More information and usage methord please refer to http://www.keil.com/pack/doc/cmsis/Driver/html/index.html.The cmsis_uart_interrupt_transfer example shows how to use uart cmsis driver in interrupt way:In this example, one uart instance connect to PC through uart, the board willsend back all characters that PC send to the board.Note: The example echo every 8 characters, so input 8 characters every time.

The FTM project is a demonstration program of generating a combined PWM signal by the SDK FTM driver. It sets up the FTMhardware block to output PWM signals on two TPM channels. The example also shows the complementary mode of operationand deadtime insertion.On boards that have 2 LEDs connected to the FTM pins, the user will see a change in LED brightness.And if the board do not support LEDs to show, the outputs can be observed by oscilloscope.

The FTM project is a demonstration program of the SDK FTM driver's dual-edge capture feature.This feature is available only on certain SoC's.The example sets up a FTM channel-pair for dual-edge capture. Once the input signal is received,this example will print the capture values and period of the input signal on the terminal window.

The FTM project is a demonstration program of the SDK FTM driver's input capture feature.The example sets up a FTM channel for dual-edge capture. Once the input signal is received,this example will print the capture value.

The FTM project is a demonstration program of the SDK FTM driver's output compare feature.It sets up one FTM channel to toggle the output when a match occurs with the channel value. The usershould probe the FTM output with a oscilloscope to see the signal toggling.

The FTM pwm two channel Example project is a demonstration program that uses the KSDK software to generate a square pulse PWM on 2 channel to control the LED brightness.- FTM generates a PWM with the increasing and decreasing duty cycle.- LED brightness is increasing and then dimming. This is a continuous process.

The FTM project is a simple demonstration program of the SDK FTM driver. It sets up the FTMhardware block to output a center-aligned PWM signal. The PWM dutycycle is periodically updated.On boards that have an LED connected to the FTM pins, the user will see a change in LED brightness.

The FTM project is a simple demonstration program of the SDK FTM driver to use FTM as a timer.It sets up the FTM hardware block to trigger an interrupt every 1 millisecond.When the FTM interrupt is triggered a message a printed on the UART terminal.

The GPIO Example project is a demonstration program that uses the KSDK software to manipulate the general-purposeoutputs.The example is supported by the set, clear, and toggle write-only registers for each port output data register. The example take turns to shine the LED.