STM32L4R9I-EVAL

STM32 Evaluation development board with STM32L476ZGTx MCU

• Debug Interfaces
  JTAG/SW	20-pin JTAG (0.1 inch connector)
  JTAG/SW	20-pin Cortex debug + ETM Trace (0.05 inch connector)
  JTAG/SW	10-pin JTAG STDC14 and MIPI10 interface (0.05 inch connector)
  JTAG/SW	10-pin TAG probe TC2050-IDC-NL
  ST-Link	USB

• Debug
  Integrated Debug Adaptor	1 x On-board ST-LINK/V2-1

• Other
  Crystal Oscillator	25 MHz Crystal Oscillator

• Power
  Power Supply	5 V .. 0 V USB Powered
  Power Supply	3 V .. 5 V External Supply
  Battery	1 x Coin-battery cell holder for power backup

• Memory
  RAM	1 x 16-Mbit SRAM
  RAM	1 x 64-Mbit Octo-SPI SRAM
  Flash	1 x 128-Mbit Nor Flash
  Flash	1 x 512-Mbit Octo-SPI Flash
  Other Memory Type	1 x 128-Kbit I2C EEPROM
  SD/microSD/MMC Card Holder	1 x SDIO interface microSD card

• Connectors
  USB	1 x USB 2.0 Full Speed
  CAN	1 x CAN
  RS232	1 x RS232
  Other Connector Type	1 x Pmod expansion connector
  Other Connector Type	4 x Extension connector
  Other Connector Type	1 x Motor-control connector
  Other Connector Type	1 x EXT_I2C connector

• Sensors
  Ambient Light Sensor	1 x Light-dependent resistor

• Display
  GLCD	272 x 480 4.3 inch Color TFT LCD with RGB mode with a capacitive touch
  GLCD	390 x 390 1.2 inch Color MIPI DSI round LCD with a capacitive touch
  LEDs	4 x LEDs directly connected to port pins

• Controls
  Joystick	1 x 5-position Joystick
  Potentiometer	2 x Analog Voltage Control for ADC Input (potentiometer)
  Push-buttons	3 Push-Buttons for Reset, Wake-up/Tamper and Touchkey

• Audio
  Line Out	2 x Audio CODEC with Stereo Line-Out and Speaker/Microphone
  Microphone	2 x ST-MEMS Digital microphone