STM32303E-EVAL

STM32 Evaluation development board with STM32F303VETx MCU

• Debug Interfaces
  JTAG/SW	20-pin JTAG (0.1 inch connector)
  JTAG/SW	20-pin Cortex debug + ETM Trace (0.05 inch connector)
  ST-Link	USB

• Debug
  Integrated Debug Adaptor	1 x On-board ST-LINK/V2

• Other
  Crystal Oscillator	8 MHz 8 MHz Crystal Oscillator

• Power
  Power Supply	5 V - 0 V USB Powered
  Power Supply	3 V - 5 V External Supply

• Connectors
  USB	1 x USB 2.0 Full Speed
  CAN	1 x CAN
  RS232	1 x RS232
  Other Connector Type	1 x RF-EEPROM daughterboard expansion
  Other Connector Type	2 x I/O expansion connector
  Diode	1 x IrDA transceiver
  Other Connector Type	2 x Motor control connector

• Display
  GLCD	240 x 320 2.4 inch TFT color LCD connected to the SPI interface
  LEDs	4 x LEDs directly connected to port pins
  LEDs	1 x High-brightness LED
  LEDs	1 x IR LED

• Controls
  Joystick	1 x 5-position Joystick
  Potentiometer	1 x Analog Voltage Control for ADC Input (potentiometer)
  Push-buttons	2 Push-Buttons for Reset, Key
  Touch keys/Area	2 x Touch sensing button

• Memory
  SD/microSD/MMC Card Holder	1 x microSD card
  Other Memory Type	1 x 1-Mbit SPI EEPROM

• Sensors
  Other Sensor	1 x Humidity sensor
  Temperature Sensor	1 x Temperature sensor
  Ambient Light Sensor	1 x Light-dependent resistor

• Audio
  Line Out	1 x Audio Codec DAC and ADC, stereo audio jack which supports headset with microphone

• I/O
  Digital I/Os	52 x Daughterboard Extension header 1
  Digital I/Os	52 x Daughterboard Extension header 2